|
|
| |||||||||||
|
|
|
| ||||||
 |
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov (This item was manufactured prior to August 31st, 2018) Click to see Why is this here?
As of August 2018 the State of California has changed the requirements of the Prop 65 law. We now must list on our website any possible chemicals the can cause cancer, birth defects or reproductive problem.
As an example: ABS plastic contains styrene PVC wire insulation can contain Di(2-ethylhexyl)phthalate (DEHP) electrolytic capacitors can contain Ethylene glycol Brass can contain Lead flame retardant pc boards can contain Tetrabromobisphenol A (TBBPA) Aluminum alloys can contain Chromium To put it simply we are a small company and do not have the resources to test every single part, so we list every thing as hazardous. Please recycle all electronic parts responsibly and under no circumstance eat, drink or smoke these parts and wash your hands after touching! |
Product Reviews Click here to review this item | ||
| ||
 |
Use of pump | |
| I also bought these pumps 10+ to repair some Keurig K-cup coffee units as well as some R/D projects. I never received a defective one but did receive one that I thought was a little too scruffy. mpja.com replaced it for me. P/S it worked ok it was a visual thing. | ||
| - Handy Andy, MI | ||
 |
Its a cute little 12v pump | |
| I only see 5 psi, but its quiet and very low current. The one I got will start at 5v, and build a psi or so at 6v. It draws 50ma at 13v, and 100ma at full pressure. | ||
| Bob Dob | ||
|
Keurig pump | |
| I bought several of these to repair Keurig K-cup coffee makers. This air pump is used in many Keurig models to push the hot water thru the K-cup while brewing. | ||
| - Kerry, IL | ||
|
Paul Z | |
| I ordered eight more of these. All of them work and all are below 40ma with no load. These are a real bargain compared to the same pump used on other web sites. | ||
|
Quiet solid | |
| I ordered one pump for a review. It measured at 10 PSI. I will use it to activate small cylinders in a robot hand. I ordered ten more based on my evaluation. | ||
| - Paul Mattaboni, AZ | ||
|
30ma not 300ma | |
| I ordered three and all work. I tested all three and with no load back pressure they consume 34ma, not 300ma as advertised. This makes them ideal for battery operation. Two of my pumps will serve as a redundant, automatic, emergency air supply for my 170 gal aquarium with 2,000+ guppies. With a 65 AHr deep cycle battery, the emergency air supply will run for many days. The bracket is awkward to use without some additional method of holding the pump in place. | ||
| - Paul Z, NH | ||
 |
Used parts | |
| Out of the 4 that I ordered only 2 worked. However, for $5 you can loose a few. Cost more the send the 2 back than they are worth. The lowest price I could find other places was $20 on sale. Perhaps MPJA should screen them. | ||
| Mac | ||
